This is kind of a simple project but one of my favorites! Our wedding colors are black, white, and green so I wanted our ring bearer to carry a pillow with a little flare. After looking around at a few pre-made options and coming up empty handed, I decided to make one myself! The supplies I used are:
• Fabric (1/2 yard at most)
• Sewing thread to match fabric
• 1” satin ribbon
• Polyfill stuffing
I wanted the pillow to be about a 9 inch square, so I cut two pieces of fabric into 10 inch squares. A word to the wise – make sure that if your fabric has a pattern, it is centered on each of the squares as you’re cutting them out. I learned the hard way that you don’t want things to look off center!
So essentially, you cut out two squares, turn the fabric so that the right sides are facing each other, and sew them together. Leave about a two inch gap on one of the sides and use that to pull the fabric through so you can turn the pillow right side out. Then, stuff away! I found that a pencil worked well to push the filling into the corners but I honestly can’t tell you how much stuffing I used. I kept putting it in and then feeling the consistency until it seemed right.
Once the stuffing is complete just use a needle and some more thread to sew the gap together. Then make your ribbon as long as you want it (depending on how much length you want to hang off the pillow) and put the middle of the ribbon in the center of the pillow. Take another needle and thread and gently sew the ribbon into the middle so that it’s attached to the pillow. Then all you have to do is tie a bow!
And here is a close-up of the back, so you can see the importance of getting that pattern centered:
No comments:
Post a Comment